Ergotron WorkFit-B Podręcznik Użytkownika Pobierz pdf (Strona 15)

15 of 18

888-24-227-G-00 rev. B • 07/13

14mm

Release the hand brake (on the right leg) and move

the worksurface up to highest level.

Push in the cover located behind each leg to access

the adjustment point.

Maintain equal amount of tension on both legs by

alternating the adjustment from one leg to the other

using a 14mm socket drill.

Adjustment Step

Make sure

covers are fully

closed before

lowering the

worksurface.

NOTE: The covers on the legs will not open

unless the worksurface has been lifted to it’s full

height. The worksurface will not lower unless

the covers have been completely closed.

WARNING! DO NOT tip desk over to adjust. Only perform adjustment while desk is upright.

Failure to follow these instructions may cause the lift engine to expand rapidly and may result in

equipment damage and or personal injury.

Increase Lift Strength

If the mounted weight is too heavy or this

product does not stay up when raised, then you'll

need to increase Lift Strength:

Decrease Lift Strength

If the mounted weight is too light or this product

does not stay down when lowered, then you'll

need to decrease Lift Strength:

1 2 ... 10 11 12 13 14 15 16 17 18

Brak uwag

Ergotron WorkFit-B Podręcznik Użytkownika Strona 15